Idiomas disponibles
Idiomas disponibles
Fig.47
► 1. Adjusting screw for 0° angle 2. Adjusting screw
for 45° angle
3.
Tighten the clamping screws and then make a test
cut to check if desired angle is obtained.
Adjusting the depth guide
If the base does not slide up or down smoothly, the
depth guide may have been tilted. You can adjust the
depth guide as follows:
1.
Make the base perpendicular, and set the depth of
cut to the deepest.
2.
Loosen the adjusting screws for the depth guide.
The depth guide automatically adjusts its position.
3.
Tighten the adjusting screws for the depth guide.
4.
Adjust the parallelism by referring to the section
for parallelism.
Fig.48
► 1. Adjusting screws for the depth guide
1
2
1
Adjusting the parallelism
CAUTION:
Keep the parallelism accurate.
Otherwise the circular saw blade may bite into the
guide rail and the damaged guide rail may cause an
injury.
This adjustment has been made at the factory. But if it is
off, you can adjust it as the following procedure.
1.
Set the tool to the maximum cutting depth.
2.
Make sure all levers and screws are tightened.
3.
Loosen the screws shown in the figure.
4.
While opening the lower guard, move the rear of
the base so that the distance A and B becomes equal.
1
Fig.49
► 1. Screw 2. Base
5.
Tighten the screws and make a test cut to check
the parallelism.
OPTIONAL ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
•
Circular saw blade
•
Sub base
•
Guide rail
•
Bevel guide
•
Clamp
•
Sheet
•
Rubber sheet
•
Position sheet
•
Hex wrench
•
Front cuff 24
•
Wireless unit
•
Makita genuine battery and charger
23 ENGLISH
A
B
2
1
