Idiomas disponibles
Idiomas disponibles
P
REPARATION
No supplied cables are used in this connection:
Please purchase the necessary cables at your local store.
High Speed HDMI cable (also known as HDMI category 2 cable) is recommended for the better compatibility.
Before you connect...
Be sure your antenna or other device is connected properly before plugging in the AC power cord.
Antenna Connection
Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.
e.g.)
VHF / UHF
antenna
or
cable TV signal
* Once connections are completed, turn on the unit and begin initial setup. Channel scanning is necessary for the unit
to memorize all available channels in your area. Refer to "Initial Setup" on page 15.
Note:
• If you have any question about the DTV's antenna, visit www.antennaweb.org for further information.
• Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local
electronics store for these items.
• For your safety and to avoid damage to this unit, please unplug the RF coaxial cable from the antenna input jack before moving the unit.
• If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than
settop versions.
• To switch your reception source easily between antenna and cable, install an antenna selector.
• If you are not receiving a signal from your cable service, contact the Cable provider.
Connection to Cable Receiver or Satellite Box
Use an HDMI or a component video cable to connect the HDMI or the Component video Input jack of the unit to the
HDMI or the component video output jack of the cable receiver / satellite box.
If you connect to the unit's Component video Input jack, connect audio cables to the Audio L/R jacks below the
Component video connector.
e.g.)
satellite dish
or
cable TV signal
including PPV
* You can also connect this unit to the cable receiver or satellite box other than the HDMI or the component video
output jack because they might have different output jacks.
* Required cables and connecting methods of the cable receiver / satellite box, or the availability channel for the
clear QAM may differ depending on the cable / satellite provider. For more information, please contact your cable /
satellite provider.
10
10
EN
RF coaxial cable
HDMI OUT
or
AUDIO OUT
L
ANT IN
RF coaxial
cable
STEREO
PCM
cable receiver / satellite box
HDMI cable
or
COMPONENT VIDEO OUT
R
Y
Pb/Cb
Pr/Cr
(green)
(green)
( ( green)
(green)
(green)
green)
reen)
(bl
b b b (blue)
(blue)
(blue) e)
(blue)
e)
)
)
(red)
(red)
(red)
(red) d d d
(red)
component video cable
and audio cable
rear of this unit
side or
rear of this unit
(green)
(green)
(green)
(green)
green)
green) )
) n
(blue)
(blue)
(blue)
bl
u
)
)
(red)
(red)
(red)
red)
