Preparation; Antenna Connection; Connection To Cable Receiver Or Satellite Box - Sylvania LC220SL1 Manual Del Propietário

PREPARATION

No supplied cables are used with these connections:
Please purchase the necessary cables at your local store.
High Speed HDMI cable (also known as HDMI category 2
cable) is recommended for the better compatibility.
Before you connect:
Be sure your antenna or other device is connected properly
before plugging in the AC power cord.

Antenna Connection

Connect the RF coaxial cable on your home outlet to the
antenna input jack of this unit.
e.g.)
VHF / UHF
analog or
DTV antenna
or
cable TV signal
Once connections are completed, turn on the unit and begin initial
setup. Channel scanning is necessary for the unit to memorize all
available channels in your area. [Initial Setup] ➠ p. 15
Note
•
If you have any question about the DTV's antenna, visit www.antennaweb.
org for further information.
•
Depending on your antenna system, you may need different types of
combiners (mixers) or separators (splitters). Contact your local electronics
store for these items.
•
For your safety and to avoid damage to this unit, please unplug the RF
coaxial cable from the antenna input jack before moving the unit.
•
If you use an antenna to receive analog TV, it should also work for DTV
reception. Outdoor or attic antennas will be more effective than a set top
or inside antenna.
•
To switch your reception source easily between antenna and cable, install an
antenna selector.
•
If you are not receiving a signal from your cable service, contact the Cable
provider.
RF coaxial cable
rear of this unit
Connection to Cable Receiver or
Satellite Box
Use an HDMI or component video cables to connect the
HDMI or the Component Video Input jacks of the unit to
the HDMI or the component video output jacks of the cable
receiver / satellite box.
If you connect to the unit's Component Video Input jacks,
connect audio cables to the Audio L/R Input jacks right beside
the Component Video connector.
e.g.)
satellite dish
or
cable TV signal
cable receiver /
including PPV
HDMI OUT
HDMI cable
side or rear of
this unit
You can also connect this unit to the cable receiver or satellite box
other than the HDMI or the component video output jacks because
they might have different output jacks.
Required cables and connecting methods of the cable receiver /
satellite box, or the availability channel for the clear QAM may differ
depending on the cable / satellite provider. For more information,
please contact your cable / satellite provider.
RF coaxial cable
satellite box
STEREO
PCM
AUDIO OUT
COMPONENT VIDEO OUT
or
L R Y Pb/Cb
(green) r r b b b (blue)
component video cables component video cables component video cables e id b
(red/blue/green ( d/bl / (red/blue/green) red/blue/green) / ) and audio cables and audio c d audio cables audio ca d d
SERVICE
TERMINAL
or
HDMI 2 HDMI 2
(green) re
b b (blue)
(red) re red d
English
ANT IN
Pr/Cr
(red) r r d d d
9
EN