Idiomas disponibles
Idiomas disponibles
Phase 2
(Fig. B)
(1) Hook the Range Hood on the support bar (A).
(2) Adjust the alignment of the Range Hood, using the fixing screws. The upper screw (D) adjusts the distance from the wall, the
lower one (E) the vertical scrolling.
(3) Remove the perimeter suction panel (F) and the metal filters (G).
(4) To prevent the Range Hood from falling due to a pressure below, fasten it to the wall with 2 relative screw (V2 Ø4.5x40) using
the appropriate holes on the back of the Range Hood.
B
(1)
A
(3)
Pin
Please slowly remove the pin while
supporting it with fingers so that it
will not fall.
14
(2)
D
(4)
3
1
F
2
2 - Ø4.5 x 40
Mandatory safety screws
4
G
8
Metal filter protective film must be removed.
E
V2
5
7
6
F
