Bosch GWS18V-10 Instrucciones De Funcionamiento Y Seguridad página 13

2610068708 11-21 GWS18V-10.qxp_GWS 11/17/21 12:41 PM Page 13
measures reduce the risk of starting the tool accidentally.
Wheel Guard Installation
grinding or cutting wheels. Always keep
wheel guard be tween you and your work
while grinding or cutting.
TO ATTACH WHEEL GUARD
Disconnect battery pack from tool.
Press and hold the release lever (Fig. 2),
and place the guard on the guard mounting
flange until the guard's keys line up with the
notches in the spindle collar (Fig. 2A).
Press the guard onto the guard mounting
flange until the shoulder of the guard is
seated against the flange of the tool, and
turn the guard until it can clearly be heard
to engage.
Adjust the position of the guard to the
requirements of the work process. For this,
press the release lever upward and turn the
guard until it clicks into place then adjust as
needed.
• Always adjust the guard in such a manner
that all 3 red cams of release lever engage
into the corresponding notches of the
guard (Fig. 2B).
• Adjust the guard in such a manner that
sparking is prevented in the direction of
the operator.
• The guard should turn only upon
actuation of the release lever! Otherwise
the tool may not continue to be used under any circumstances and must be
taken to an after-sales service agent.
Note: The encoding keys on the guard
ensure that only a guard that fits the tool
type can be mounted.
TO REMOVE GUARD
Press release lever, rotate guard until the keys
on guard line up with the notches on the
guard mounting flange, and lift guard off the
guard mounting flange (Fig. 2).
Assembly
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories. Such preventive safety
Wheel guard must be
attached when using disc
GUARD
RELEASE
LEVER
A
-13-
FIG. 2
GUARD
MOUNTING
FLANGE
KEYS
B