Idiomas disponibles
Idiomas disponibles
Predetermined
breaking point
To prevent serious damage to your
appliance if the mincer is overloaded, the
driver has a notch (predetermined breaking
point). If an overload occurs, the driver
breaks instead. However, the driver can
easily be replaced.
Otherwise spare parts with a predetermined
breaking point are not a component of our
warranty obligations.
Such spare parts can be purchased from
customer service (order no. 753348).
Operation
W Risk of injury!
Do not insert mains plug until all
preparations for working with the appliance
are complete.
■ Before operating the appliance
and accessories for the first time,
clean thoroughly; see "Cleaning and
servicing".
X Fig. B
■ Stow perforated discs in the storage
compartment.
■ Stow individual parts of the sausage
filler attachment and kebbe attachment
in the pusher and close the pusher with
the lid.
Assembling the mincer
attachment
X Fig. C
■ Take perforated disc with required
hole diameter out of the storage
compartment.
■ Insert worm gear into the housing.
■ Put blade on the worm gear. Blades
must face the perforated disc.
■ Put perforated disc with the required
hole diameter on the worm gear.
Recess on the perforated disc must
be situated on the lug in the housing.
■ Screw on threaded ring clockwise. Do
not tighten the threaded ring too tight.
■ Disassembly is in reverse order.
Predetermined breaking point
Use for:
– processing raw or cooked meat, bacon,
poultry and fish.
– Do not process bones!
– Process steak tartare through the
mincer twice.
Assembling sausage filler
attachment
Note: The parts of the mincer attachment
(without perforated disc and blade) are
used.
X Fig. D
■ Take nozzle (A) and bearing ring (D) out
of the pusher.
■ Insert worm gear into the housing.
■ Insert nozzle into the threaded ring.
■ Put bearing ring on the worm gear and
hold in place. Recess on the bearing
ring must be situated on the lug in
the housing.
■ Screw on threaded ring with nozzle
clockwise. Do not tighten the threaded
ring too tight.
■ Disassembly is in reverse order.
Use for:
Filling artificial and natural casings with
sausage meat.
Assembling kebbe attachment
Note: The parts of the mincer attachment
(without perforated disc and blade) are
used.
X Fig. E
■ Take shaper (B) and conical ring (C) out
of the pusher.
■ Insert worm gear into the housing.
■ Insert shaper into threaded ring.
■ Put conical ring on the worm gear and
hold in place. Recess on the conical
ring must be situated on the lug in
the housing.
■ Screw on threaded ring with shaper
clockwise. Do not tighten the threaded
ring too tight.
■ Disassembly is in reverse order.
Use for:
Shaping dough tubes.
en
15
