Specifications - Sony CDX-RW300 Manual De Instrucciones

Specifications

AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
23.2 watts per channel minimum continuous average power into 4 ohms,
4 channels driven from 20 Hz to 20 kHz with no more than 5% total
harmonic distortion.
CD Player section
Signal-to-noise ratio
Frequency response
Wow and flutter
Tuner section
FM
Tuning range
Antenna terminal
Intermediate frequency
Usable sensitivity
Selectivity
Signal-to-noise ratio
Harmonic distortion at 1 kHz
Separation
Frequency response
AM
Tuning range
Antenna terminal
Intermediate frequency
Sensitivity
Power amplifier section
Outputs
Speaker impedance
Maximum power output
120 dB
10 – 20,000 Hz
Below measurable limit
87.5 – 107.9 MHz
External antenna connector
10.7 MHz /450 kHz
9 dBf
75 dB at 400 kHz
67 dB (stereo),
69 dB (mono)
0.5 % (stereo),
0.3 % (mono)
35 dB at 1 kHz
30 – 15,000 Hz
530 – 1,710 kHz
External antenna connector
10.7 MHz/450 kHz
30 µV
Speaker outputs
(sure seal connectors)
4 – 8 ohms
52 W × 4 (at 4 ohms)
General
Outputs
Input
Tone controls
Power requirements
Dimensions
Mounting dimensions
Mass
Supplied accessories
Optional accessory
Design and specifications are subject to change
without notice.
Audio outputs terminal
(rear/sub switchable)
Power antenna relay control
terminal
Power amplifier control
terminal
Antenna input terminal
Low:
±10 dB at 60 Hz (XPLOD)
Mid:
±10 dB at 1 kHz (XPLOD)
High:
±10 dB at 10 kHz (XPLOD)
12 V DC car battery
(negative ground)
Approx. 178 × 50 × 179 mm
× 2 × 7
1 1
(7 / / in) (w/h/d)
8 8
Approx. 182 × 53 × 161 mm
× 2 × 6
1 1 3
(7 / / / in)
4 8 8
(w/h/d)
Approx. 1.2 kg
(2 lb 10 oz)
Parts for installation and
connections (1 set)
Front panel case (1)
Card remote commander
RM-X114
17