Regalo 1166H Manual De Instrucciones página 4

STEP 7
OUTER HOUSING
RECEIVING
COMPONENT
When you are satisfied with the general placement
of your gate, fully tighten the threaded spindle rods
attached to the lower corners of the gate by further
rotating the adjustment wheels. Continue by
tightening the upper threaded spindle rods. As you
tighten the threaded spindle rods, you will notice the
gap between the door frame and the secure lift latch
begin to narrow. In order for the gate to function
properly, stop tightening the upper threaded spindle
rods just before the outer housing of the secure lift
latch and the receiving component touch.
NOTE:
There should be equal spacing among each
of the (4) threaded spindle rods. Make the
appropriate adjustment to ensure you have installed
your gate safely.
Positioning and Attaching Wall Cups
STEP 1
After you have mounted your gate, and you are
satisfied with its positioning, draw a circle on the
surface of your doorway or opening around the
perimeter of the (4) rubber feet.
Next, completely remove the gate from the
opening by loosening each of the (4) threaded
spindle rods to depressurize the gate.
Operating the Door Latch
STEP 1
Pull the spring lock away from the secure lift
latch while simultaneously lifting the lock
lever upwards. This will release the locking
latch from the gate frame and allow the door
to push or pull open.
To lock the door shut, close the door completely,
then push down on the lock lever to re-engage
the spring lock.
NOTE:
If your secure lift latch is not properly
engaging with the receiving component, ensure
that your gate is level, mounted properly, and
that you have not over-tightened the threaded
spindle rods.
STEP 2
With gate fully removed, you can now use the circles
you marked during Step 1 as guides for screwing in
your (4) wall cups (F). Center each of the wall cups
within the guide circles and use the provided
self-tapping screws (G) to fasten them in place via the
hole through the center of each wall cup.
STEP 2
SPRING LOCK
LOCK LEVER
BASE LOCK
At the bottom of the gate door, rotate the
base lock to the horizontal position to
allow the door to swing open.
NOTE:
Place lock down on side occupied
by the child.
STEP 3
Reinstall your gate in the doorway or opening
according to the instructions, using the newly
installed wall cups as anchoring points for the
(4) threaded spindle rods.