S&P FIRE FAN P Instrucciones De Uso página 5

Ocultar thumbs Ver también para FIRE FAN P:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
ENGLISH
Instructions for use FIRE FAN P ON / OFF
1. INTRODUCTION
Please read these instructions carefully before
using the appliance.
The FIRE FAN convection air heater complies
with European regulations EN-60335-2-30. It is
recommended to check the state of the appli-
ance when it is unpacked, any factory defect is
covered by the guarantee.
2. IMPORTANT INSTRUCTIONS SAFETY
WARNINGS
• The appliance must not be placed immedi-
ately below an electrical socket.
• Do not cover the appliance with objects or
garments that impede the free circulation of
air. Covering the unit may cause it to over-
heat.
• While the appliance is in operation, the cable
must not be in front of the air outlet.
• Do not use this heater in the immediate vi-
cinity of a bathtub, shower or swimming
pool.
• Do not use this heater if it has been dropped.
• Do not use if there are visible signs of dam-
age to the heater.
• Use this heating appliance on a horizontal
and stable surface, or if possible fi x it to a
wall.
• No infl ammable objects should be placed at
less than 50 cm from the hot air fl ow (cur-
tains, etc.).
• Keep the air inlet and outlet grilles clean.
When cleaning the appliance, always discon-
nect it from the mains.
• Do not manipulate with wet hands.
• If the fl exible power cord is damaged, it must
be replaced in one of our repair shops or by
similar qualifi ed personnel to avoid hazards.
• This appliance is not designed for use by
sensorial of physically handicapped people
(or children), or people without experience
or knowledge, unless supervised or unless
they have been instructed about how to use
the appliance by soemone in charge of them.
• Children must be supervised to ensure they
do not play with the appliance.
3. OPERATION
• Make sure that the mains voltage coincides
with that indicated on the specifi cations
plate.
• Plug the cable into the mains socket and set
the switch to ON.
• Switching off. Set the switch to stop position.
Fireplace function
Once it has been checked that the fl ue is open,
place the FIRE FAN convection air heater at the
base of the fl ue, resting on its rubber blocks,
avoid placing it on papers, twigs or soot. Switch
on for 10-15 minutes to heat the column of air
inside. With FIRE FAN removed from the fi re-
place area, place the wood in the fi replace and
you can easily proceed to light the fi re.
4. MANTENANCE
1. Unplug the appliance from the mains before
carrying out any maintenance operations on
it.
2. Every season, clean out the dust accumulat-
ed inside with compressed air blown through
the inlet and outlet grilles. It is recommend-
ed for this operation to be carried out by pro-
fessional.
3. Clean the air inlet and outlet grilles regular-
ly.
4. Do not immerse the appliance in water or
rinse it under the tap.
5. Do not dismantle or modify the appliance as
this would automatically cancel the guaran-
tee.
6. If you detect any anomaly, contact one of our
many offi cial S&P servicing shops.
EN
5
loading