Idiomas disponibles
Idiomas disponibles
asberprofessional.com
The steps to be followed in the event of a fault or operating error are described below. The possible causes
and possible solutions are listed in the following table. In the event of doubt, or if you are unable to resolve the
problem, please contact the technical service.
FAULT
The machine does not come
on
The machine does not fill
with water.
Unsatisfactory wash
Dishes and kitchenware are
not dry
Scratches or stains on
dishes.
51
asberprofessional.com
7. FAULTS, ALARMS AND BREAKDOWNS
Do not handle electrical components as there is a risk of death as the
POSSIBLE CAUSE
There is no power
supply.
The fuses have blown.
Main switch open.
Water entrance valve
closed.
Rinse nozzles blocked.
Solenoid valve filter
blocked.
Pressure switch bro‐
ken
Wash
obstructed.
Shortage of detergent. Call the technical service to reset the dispenser.
Dirty filters.
Presence of foam
Temperature of tub
lower than 50 ⁰C / 122
⁰F.
Length of cycle too
short for level of dirt
on dishes.
Water too dirty.
There is no rinse aid
Insufficient rinse aid.
Dishes
dishwasher for too
long.
Rinse
lower than 80 ⁰C / 176
⁰F
Too much rinse aid.
Water too chalky.
Not enough salt in salt
deposit.
Traces of salt in tub.
components are live.
SOLUTION
Check whether the magneto‐thermal circuit
breaker has been triggered.
Call the technical service to analyse the reason why.
Close switch.
Open the water valve.
Clean nozzles and check branches for build‐up of
lime.
Call the technical service to clean the filter.
Call the technical service to replace the pressure
switch.
distributors
Clean distributors thoroughly.
Clean the filters thoroughly.
Unsuitable detergent or too much rinse aid. Call the
technical service to supply correct detergent or to
reset rinse aid dispenser.
Thermostat faulty or incorrectly set. Call the techni‐
cal service to repair it.
Select a longer cycle.
Drain the wash tub and fill with clean water.
Fill the rinse aid container.
Call technical service to adjust dispenser.
left
inside
When the dishwasher finishes, remove the basket
from the machine and allow to dry naturally.
temperature
Call technical service to analyse problem.
Call technical service to adjust rinse aid dispenser.
Check water hardness and if possible run regenera‐
tion cycle immediately
Fill salt deposit where applicable.
When filling the salt deposit, take care not to spill
salt in the tub.
ENGLISH
