Idiomas disponibles
Idiomas disponibles
Chapter 6. Machine adjustment and setting up
6.4. Reel support and packaging plate adjustment
The reel support (4) and the packaging plate (11) must be
adjusted according to the width of the article to be packaged,
leaving a space of about 1-2 cm between the article and the
welding edge.
6.5. Making the first seal
Place film as shown in the picture to carry out the 1st seal.
Lower the handle of the cover with your left hand and make a
pressure of 10-15 Kg.
Machine will automatically operate and the first seal will be
carried out on the side of the film.
With the right hand detach the film from the sealing blade.
6.6. Film binding on rewinder (if present)
Carry out a number of cycles sufficient to make a strip of scrap
film.
Guide this film strip around the transmission rollers (26) and (27)
and the control roller (28) and bind it to the rewinder (29).
The machine is now ready to start packaging.
6.7. Introducing the object to be packaged
With the left hand slide on the packaging plate the quantity of
film necessary to contain the product to be packed.
Introduce the product into the bag using the right hand and make
it slide to the left until it is laid on the screen leaving a little space
of about 1-2 cm to allow the passage of air for shrinkwrapping.
6.8. Packaging
By pushing the cover handle with a pressure of 15 Kg. the cover
rests on the sealing blade; by pinching the film, it is automatically
sealed on the open sides (right and front).
In case you have selected the function "SEALING +
SHRINKWRAPPING" (programs P02÷P10) you will see the film
shrink onto the product.
Slightly decrease the pressure on the cover handle to allow film
detach from the sealing area on the inside.
With the right and detach the film from the sealing blade towards
the outside.
21
EN
