HIKVISION DS-2XE6445G0-IZS/304 Guia De Inicio Rapido página 9

battery is replaced by an incorrect
type. Dispose of used batteries
according to the instructions.

ATTENTION: IL Y A RISQUE
D'EXPLOSION SI LA BATTERIE EST
REMPLACÉE PAR UNE BATTERIE DE
TYPE INCORRECT. METTRE AU REBUT
LES BATTERIES USAGÉES
CONFORMÉMENT AUX
INSTRUCTIONS.

Improper replacement of the battery
with an incorrect type may defeat a
safeguard (for example, in the case
of some lithium battery types).

Do not dispose of the battery into
fire or a hot oven, or mechanically
crush or cut the battery, which may
result in an explosion.

Do not leave the battery in an
extremely high temperature
surrounding environment, which
may result in an explosion or the
leakage of flammable liquid or gas.

Do not subject the battery to
extremely low air pressure, which
may result in an explosion or the
leakage of flammable liquid or gas.

+ identifies the positive terminal(s)
of equipment which is used with, or
generates direct current. - identifies
the negative terminal(s) of
equipment which is used with, or
generates direct current.
Fire Prevention

No naked flame sources, such as
lighted candles, should be placed on
the equipment.

The serial port of the equipment is
used for debugging only.
Hot Surface Prevention
CAUTION: Hot parts!
Burned fingers when
Network Bullet Camera·Quick Start Guide
handling the parts. Wait one-half hour
after switching off before handling parts.
This sticker is to indicate that the marked
item can be hot and should not be
touched without taking care. For device
with this sticker, this device is intended
for installation in a restricted access
location, access can only be gained by
service persons or by users who have
been instructed about the reasons for the
restrictions applied to the location and
about any precautions that shall be
taken.
Installation

Install the equipment according to
the instructions in this manual.

To prevent injury, this equipment
must be securely attached to the
floor/wall in accordance with the
installation instructions.

Never place the equipment in an
unstable location. The equipment
may fall, causing serious personal
injury or death.
Power Supply

The input voltage should conform to
IEC 60950-1 standard: SELV (Safety
Extra Low Voltage) and the Limited
Power Source. Refer to the
appropriate documentation for
detailed information.

The power source should meet
limited power source or PS2
requirements according to IEC
60950-1 or IEC 62368-1 standard.

DO NOT connect multiple devices to
one power adapter, to avoid
over-heating or fire hazards caused
by overload.

Make sure the plug is properly
connected to the power socket.
White Light Illuminator (If supported)
7