puissance isotrope rayonnée équivalente (p.i.r.e.)
ne dépasse pas l'intensité nécessaire à
l'établissement d'une communication
satisfaisante.
This equipment should be installed and operated
with a minimum distance 20 cm between the
radiator and your body.
Cet équipement doit être installé et utilisé à une
distance minimale de 20 cm entre le radiateur
et votre corps.
KC
B급 기기: 이 기기는 가정용(B급)
전자파적합기기로써 주로 가정에서 사용하는
것을 목적으로 하며, 모든 지역에서 사용할
수 있습니다.
Safety Instruction
These instructions are intended to ensure that the
user can use the product correctly to avoid danger
or property loss.
Laws and Regulations
The device should be used in compliance with
local laws, electrical safety regulations, and fire
prevention regulations.
Electricity
In the use of the product, you must be in strict
compliance with the electrical safety regulations
of the nation and region. The equipment shall not
be exposed to dripping or splashing and that no
objects filled with liquids, such as vases, shall be
placed on the equipment. Provide a surge
suppressor at the inlet opening of the equipment
under special conditions such as the mountain top,
iron tower, and forest. CAUTION: To reduce the
risk of fire, replace only with the same type and
rating of fuse.
Battery
Do not ingest battery. Chemical burn hazard! This
product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause
severe internal burns in just 2 hours and can lead to
death. Keep new and used batteries away from
children. If the battery compartment does not
close securely, stop using the product and keep it
away from children. If you think batteries might
have been swallowed or placed inside any part of
the body, seek immediate medical attention.
CAUTION: Risk of explosion if the battery is
replaced by an incorrect type. Dispose of used
batteries according to the instructions. Improper
replacement of the battery with an incorrect type
may defeat a safeguard (for example, in the case
of some lithium battery types). Do not dispose of
the battery into fire or a hot oven, or
mechanically crush or cut the battery, which may
result in an explosion. Do not leave the battery in
an extremely high temperature surrounding
environment, which may result in an explosion or
the leakage of flammable liquid or gas. Do not
subject the battery to extremely low air pressure,
which may result in an explosion or the leakage of
flammable liquid or gas. + identifies the positive
terminal(s) of equipment which is used with, or
generates direct current. - identifies the negative
terminal(s) of equipment which is used with, or
generates direct current.
Fire Prevention
No naked flame sources, such as lighted candles,
should be placed on the equipment. The serial
port of the equipment is used for debugging only.
Hot Surface Prevention
CAUTION: Hot parts! Burned fingers when
handling the parts. Wait one-half hour after
switching off before handling parts. This sticker is
to indicate that the marked item can be hot and
should not be touched without
taking care. For device with
this sticker, this device is
intended for installation in a
restricted access location, access can only be
gained by service persons or by users who have
been instructed about the reasons for the
restrictions applied to the location and about any
precautions that shall be taken.
Installation
Install the equipment according to the
instructions in this manual.
Power Supply
Device powered by Safety Extra-Low
Voltage(SELV): The power source should meet
limited power source or PS2 requirements
according to IEC 60950-1 or IEC 62368-1 standard.
Device powered by AC mains supply voltage: The
equipment must be connected to an earthed
mains socket-outlet. An appropriate readily
accessible disconnect device shall be incorporated
external to the equipment. An appropriate
overcurrent protective device shall be
incorporated external to the equipment, not
exceeding the specification of the building. An
all-pole mains switch shall be incorporated in the
electrical installation of the building. Ensure
correct wiring of the terminals for connection to
an AC mains supply. The equipment has been
designed, when required, modified for connection
to an IT power distribution system.
White Light Illuminator (If supported)
Possibly hazardous optical radiation emitted from
this product. DO NOT stare at operating light
source. May be harmful to the eyes. Wear
appropriate eye protection or DO NOT turn on the
white light when you assemble, install or maintain
the camera.
Transportation
Keep the device in original or similar packaging
while transporting it.
System Security
The installer and user are responsible for
password and security configuration.
Maintenance
If the product does not work properly, please
contact your dealer or the nearest service center.
We shall not assume any responsibility for
problems caused by unauthorized repair or
maintenance. A few device components (e.g.,
electrolytic capacitor) require regular
replacement. The average lifespan varies, so
periodic checking is recommended. Contact your
dealer for details.
Cleaning
Please use a soft and dry cloth when clean inside
and outside surfaces of the product cover. Do not
use alkaline detergents.
Using Environment
DO NOT place the camera in extremely hot, cold,
dusty or damp locations, and do not expose it to
high electromagnetic radiation.
Emergency
If smoke, odor, or noise arises from the device,
6
