Juice BOOSTER 2 Manual Del Usuario página 21

Operating instructions
⚠ C A U T I O N
se your charging equipment exclusively at power sock-
·
ets and charging stations for which you have original
JUICE mains adapters. The device charges your vehicle
with single- or three-phase AC voltage ranging from 6
to 32 ampere (A). Use only original JUICE accessories
equipped with the original JUICE CONNECTOR.
Protect your charging equipment against damage from
·
being run over, dropped, yanked, kinked or crushed.
To prevent overheating while charging, do not expose
·
your JUICE BOOSTER 2 to direct sunlight or other
sources of heat for long periods of time. If the JUICE
BOOSTER 2 becomes overheated, charging is automat-
ically interrupted until the unit's temperature drops to
within its normal operating range.
In many countries, industrial power outlets must be
·
equipped with a Type-A residual current device (RCD).
JUICE recommends that a Type-A RCD be installed in
power sockets of any kind. Please observe the regula-
tions in force in the country of use, as these always take
precedence. As the JUICE BOOSTER 2 is already fitted
with a built-in DC residual current monitor, you don't
have to bother with pricey installation of a Type-B RCD
or Type-A power supply.
Function display
Button for charging status/mode SELECT
Green LED
AMPERE: Displays the automatically set or individually
reduced amperage value (i. e. the charge intensity).
Yellow LED
MODE: Indicates the preselected mode.
Red LED
FAULT: Displays the cause in case of a fault.
User Manual JUICE BOOSTER 2 [JTJB2-EU2R*] V 3.2
On the back of the device you'll find a How-To quick-
start guide, hazard warnings, the unit's serial number
and other product information.
Charging instructions
⚠ D A N G E R
Always perform charging operations in the specified
·
order of steps.
Always stop the charging process before you remove
·
the charger vehicle-end connector from the vehicle
charger socket.
Never disconnect any plug (neither from the power
·
socket, nor on the JUICE CONNECTOR) while the
charging process is ongoing.
Potential charging faults (FAULT) are identified on the
·
device's function display. (Further information in this
regard can be found in the section on Fault indications).
Vehicles fitted with a Type-2 charging socket lock the
·
charge coupling during the charging process, and the
coupling remains locked as long as the car is locked.
This protects the JUICE BOOSTER 2 against theft.
Should any unauthorised party disconnect the mains-
·
end cable from the power socket during the charging
process, when the cable is reconnected to the socket
the charging process will automatically continue at the
recently detected or manually reduced charge current
intensity.
Vehicle-end charging connection
Please consult the vehicle user manual for information
on plugging in the connector, locking and unlocking the
coupling, stopping the charging process, unplugging the
connector from the vehicle-end socket, and the status of
charging and the connection at the vehicle.
Changing the mains-end adapter
⚠ D A N G E R
Stop the charging process.
·
Before changing out the mains-end adapter, always first
·
unplug the mains adapter from the power socket and
the vehicle-end connector from the vehicle.
21