Idiomas disponibles
Idiomas disponibles
ENGLISH
The unit now regulates the room temperature auto-
matically via the room thermostat by automatically
switching off when the set temperature is exceeded
and switching on again when the temperature falls
below this set temperature. For this purpose, heating
level 1 or 2 must be set by the rotary switch
Note
The desired room temperature should be higher than
the current room temperature.
Switch off the unit
1. Turn the stepless control dial
thermostat anticlockwise as far as it will go
(minimum temperature setting).
2. Turn the rotary control for the heating level
to 0.
3. Unplug the mains cable from the mains socket.
4. Let the appliance cool down completely.
22
Troubleshooting
Problem
.
2
of the room
1
2
Unit without
function/not
heating
Reduced
Note
After all troubleshooting, maintenance and cleaning
work, wait at least 5 minutes before switching the unit
on again.
If the unit still does not work properly, please contact
the customer service or an authorised electrician. The
unit must then be checked and repaired if necessary.
Cause
Unit has no power
supply
Unit, mains cable
or mains plug is
defective
The room tempe-
rature is above the
temperature set
on the thermostat.
The safety thermo-
stat has tripped
No heating level
set
Air inlet and outlet
airflow
not free
Solution
Check the socket
Plug in the mains
plug correctly
Check the house
fuse
Contact customer
service or a
specialist
Increase the ther-
mostat tempe-
rature
Switch off the
appliance and
disconnect the
mains plug.
Eliminate the cau-
se of overheating
before restarting
the appliance.
Adjust the hea-
ting level
Clean and ob-
serve minimum
distances
