Dimplex BLF3451-INT Manual Del Propietário página 13

Idiomas disponibles

Idiomas disponibles

Fireplace Installation
outlet or install an outlet on
a nearby wall stud within the
wall).
• Hard wire the fireplace.
!
NOTE: Hard wiring can be done
by removing the plug from the
factory fitted cord and completing
the wiring according to National and
Local Elecrical Codes.
WARNING: Do not attempt to
wire your own new outlets or circuits.
To reduce the risk of fire, electric
shock or injury to persons, always
use a licensed electrician.
Ensure that the 3-Position Switch is
set to the Off position ("O") and that
the circuit on which the fireplace is to
be installed has the power cut off at
the service panel until installation is
complete.
3. Lift fireplace and insert into
opening.
mounting trim should be flush
against the wall (Figure 8).
4. Use bubble level (supplied) to
level the fireplace within the
framing. Adjust as required.
5. Drive four (4) supplied mounting
screws through the four (4)
mounting holes located on the
inside surface of the fireplace
chassis, into wall studs (Figure
8).
The
fireplace's
Figure 8
Wall
surface
Mounting hole
6. Refer
to
Installation section, for final
installation procedures.
Front Glass Installation
1. Evenly
glass rock on the front tray of
the fireplace (Figure 9).
2. Carefully mount front glass
assembly so that the front
glass hooks (4) hang on the
front glass mounts on the
fireplace (4) (Figure 10).
3. Use the supplied two (2)
Phillips sheet metal screws
to fasten the glass assembly
tabs to the fireplace (Figure
11).
4. Ensure
Mounting hole
Front
distribute
supplied
the
fireplace's
Glass
13
loading