Idiomas disponibles
Idiomas disponibles
Error output during the teach-in
8
Disassembly and disposal
8020148.1HRJ/2023-02-08 | SICK
Subject to change without notice
Return to operating mode with one button
Press and hold down the
setting (operating mode) without using Exit.
NOTE
Invalid while configuring the time type, counter or range.
Channel change
Press the button in operating mode to change the channel. The channel LED
changes at the same time:
1000 1200
NOTE
WI130T-P/N340 devices cannot be changed because they only have one output (1x
Out).
An error message is output if an incorrect entry is made during adjustment. See the
following table for repeating the adjustment.
Table 26: Error output during the teach-in
LED/fault pattern
Err1
Err2
Err3
not cPLt
The sensor must be disposed of in line with applicable country-specific regulations.
When disposing of them, you should try to recycle them (especially the precious met‐
als).
NOTE
Disposal of batteries, electric and electronic devices
•
According to international directives, batteries, accumulators and electrical or
electronic devices must not be disposed of in general waste.
•
The owner is obliged by law to return this devices at the end of their life to the
respective public collection points.
•
WEEE:
This symbol on the product, its package or in this document,
indicates that a product is subject to these regulations.
button for two seconds or longer to return to the normal
2000 2200
1
2
←→
Cause
Indicates the light intensity is too low.
Indicates an undetected moving object.
Indicates a calculation error.
Indicates an interruption of the teach-in.
O P E R A T I N G I N S T R U C T I O N S | Evaluation unit WI130
OPERATING INSTRUCTIONS
1
2
en
59
