cecotec BOLERO COOLMARKET FD 510 INOX E Manual De Instrucciones página 37

ENGLISH
reference.
5. CLEANING AND MAINTENANCE
Defrosting
The refrigerator features an automatic defrosting function, eliminating the need to do it
manually.
Precautions for cleaning the inside and outside of the refrigerator:
- Before cleaning, always switch off the appliance and unplug it from the mains.
- During cleaning, make sure that no water enters the switch, display, door light, and top
control panel.
- Remove dirt from the outside of the refrigerator with a soft, clean cloth and allow the
refrigerator to dry naturally.
- When cleaning the door seal, always use clean water and a dry cloth and allow it to dry
naturally. Dampen a soft cloth with lukewarm water or a neutral cleaning agent to clean
the body of the refrigerator, except for the door seal.
- Do not clean the refrigerator directly with water, as this will affect the electrical insulation
properties, among other things.
- The refrigerator must not be cleaned with metal scouring pads, brushes, abrasive cleaning
agents, strong alkaline detergents, or flammable or toxic cleaning liquids.
- After cleaning, connect the power plug of the refrigerator and switch it on again.
General information
Holiday
When on holiday, it is best to keep the refrigerator in continuous operation and leave food that
can be kept for a short time. If you wish to turn off the refrigerator, remove all food, disconnect
the power plug, clean the inside of the refrigerator thoroughly, and open the door to prevent
unpleasant odours.
In case of power failure
- Generally, a short power failure will not affect the temperature of the refrigerator abruptly.
However, if the power failure lasts for a long time, you should decrease door-opening
frequency and not put fresh food in the refrigerator (to avoid accelerating the interior
temperature rise).
- If you are aware of possible power failures, you can enable the Fast Freezing function
and the Fast Cooling function in advance to keep the refrigerator temperature at the
lowest value.
72
BOLERO COOLMARKET FD 510 INOX E / DARK E / WD INOX E / GLASS E
Switch-off
It is generally not recommended to switch off the refrigerator or unplug the power cord,
otherwise the lifetime of the refrigerator may be affected.
Energy-saving tips:
- Make sure to keep the refrigerator away from heat sources and direct sunlight.
- Before storing hot food, cool it down to room temperature and store it in the refrigerator.
- Do not leave the door open. Reduce the door-opening frequency and shorten the opening
time.
- When defrosting frozen food, you can put it in the refrigerator compartment.
- Make sure the temperature sensor is not obstructed or covered by food. Keep the food far
enough away from the sensor.
6. TROUBLESHOOTING
Normal occurrences
Button failure
- Check if the refrigerator is in lock mode–when in lock mode, the buttons do not work.
- Low voltage. The refrigerator doesn't turn on.
- It is recommended to install a voltage regulator of more than 1000 W in the installation
location of the refrigerator to better protect it.
Slow start-up
If room temperature is too high, the refrigerator takes a long time to start.
Some components heat up
Some components heat up after some time of operation of the appliance. This is normal.
Condensation droplets
When outside air enters the cold inner surface of the refrigerator, condensation droplets may
appear. If it's rainy season or humidity at the place of installation is high, condensation droplets
may appear on the outside of the refrigerator. This is a natural phenomenon that occurs in wet
weather. Wipe off the water droplets with a dry cloth.
Noise
- When the refrigerator is switched on for the first time, it will run at high speed to cool down
quickly and may emit a louder sound. When the internal temperature drops below a certain
level, the noise will decrease.
- When the refrigerator is switched on or off, when various parts expand or contract, when
BOLERO COOLMARKET FD 510 INOX E / DARK E / WD INOX E / GLASS E
ENGLISH
73