Quality Control - Cebora WIN TIG AC DC 180 M Manual De Instrucciones

9.4 TECHNICAL SETTING
To prevent inadvertent access to this menu, a password
must be set.
in the same manner.
The technical settings listed in the fi gures below are
available
By adopting this method, it is possible to select, modi-
fy and confi rm all the welding parameters which present
one after the other, and summarised in the following ta-
ble.
To return to the previous list, select and confi rm the sec-
tor return to the previous screen
Select the
To return to the main screen, press knob B (do not re-
fi rst digit,
lease immediately) (> 0.7 sec.)
press and
turn knob B

9.5 QUALITY CONTROL

and set 1.
Confi rm in This function enables checking that the arc voltage re-
order to
mains within preset values
move on to
the next dig-
it. Set the
other digits
Select and
confi rm the
parameter to
modify. disabled function. If, during welding, the voltage does
not correspond to the values set, the fl ashing wording
QUALITY CONTROL appears. Press knob B to return to
the welding screen.
10 SAVED PROGRAMS (L JOB SECTOR)
A welding spot and its parameters (process, ignition,
mode etc.) can be saved within the JOB sector, so that
the welder may access them again.
The param-
eter is acti-
vated in red;
then press
knob B.
Turn knob B
to set the
selected pa-
r a m e t e r ;
then press
to confi rm
the setting.
Select mini-
mum volt-
age (MIN) or
m a x i m u m
v o l t a g e
(MAX) then
confi rm to
set interven-
tion value.
OFF corre-
sponds with
Select and
confi rm the
JOB sector..
31