Idiomas disponibles
Idiomas disponibles
HOW TO USE
Before use, check appliance for visible damage. DO NOT USE THIS TOWER if there is evidence of damage. If any damage is found, contact
Vornado Air LLC at 1-800-234-0604.
1. Touch
to power on.
timer adjustment mode.
2. Select desired speed by pressing
The
will continue to glow orange
to indicate the timer is set.
. Speed is indicated by number of
lights illuminated:
4. To adjust timer setting,
press
.
Speed: TURBO
Speed: LOW
Timer: 12 HOURS
Timer: 3 HOURS
5. To cancel timer, cycle through the
timer settings until off. You can also
press and hold
The indicator lights will flash,
indicating the timer is off. When
Speed: HIGH
Speed: MEDIUM
timer is off, the
Timer: 9 HOURS
Timer: 6 HOURS
glow orange.
3. Press
6. Press
to turn oscillation on and
to activate timer. The
off.
and Indicator Lights will
turn orange to indicate timer
adjustment mode. While in this
You can also control the product
with Amazon Alexa. See GETTING
mode, select amount of time in
STARTED and USING ALEXA for
three-hour intervals by pressing
. After a few seconds, the
instructions.
flashing orange Indicator Lights will
turn white, indicating you have left
10 English
for 4 seconds.
will no longer
NOTE: Your tower fan is
equipped with a photodetector
sensor. The brightness of the
control display will automatically
adjust based upon the amount
of light detected in the room.
GETTING STARTED
Before product setup, download or update the Amazon Alexa app from your mobile device's app store and ensure your phone is connected to
your 2.4 GHz WIFI network.
1. Plug your Vornado OSCR37 AE into an electrical outlet.
2. Open the Alexa app and tap the MORE icon to add a device. Follow the on-screen instructions. If prompted by the app, scan the
SPEED/TIMER
INDICATOR
2D barcode located on the product.
LIGHTS
3. Once successfully connected, a message will appear in the Amazon Alexa app and the power button on your OSCR37 AE will be
POWER ON/OFF
illuminated blue. Your fan is ready to use.
FACTORY RESET: If for any reason, there is a problem with your product or you wish to disconnect the product from your network
OSCILLATION
you can reset it to factory settings. Simply press and hold the POWER and TIMER buttons for 10-15 seconds or until the entire control
panel begins to flash. To reconnect your Vornado OSCR37 AE, follow steps above.
FAN SPEED
TIMER
11
English
