Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Typical Installation
1. Gas Tight
3. Union
Basin
2. Discharge
4. Check Valve 6. Intake
Physical Installation
Risk of damage to pump or other equipment.
• Support pump and piping when assembling and when installed. Failure to do so may cause piping to break, pump
to fail, motor bearing failures, etc.
• If the relief hole in the discharge pipe is not provided, the pump could "air lock" and will not pump water even
though it will run.
• A missing, improperly installed, or malfunctioning check valve can cause a pump to short-cycle due to back-flow
of the pumped fluid from the discharge plumbing back into the basin, significantly shortening the life of the
pump.
1. Install the pump in the center of a suitable gas tight basin that is at least 18 inches (45.72 cm) in
diameter and 30 inches (76.2 cm) deep and vented in accordance with local plumbing codes.
• Ensure sump is clean and free of nails, gravel, string, cloth, or other debris before installing.
• Provide adequate room for future servicing, protection from freezing temperatures, flooding,
and equipment drainage.
• Never place the pump directly on clay, earth, or gravel surfaces.
IMPORTANT: Do not attempt to restrict the intake side of the pump.
5
4
3
2
6
10
7
5. Gate
7. Air Bleed
Valve
8. Vent
9
See
9.
Hole
on page
10. Caulking Hub
INSTALLATION
Typical Installation
8
1
"Electrical Connections"
4.
3
Tabla de contenido
