Idiomas disponibles
Idiomas disponibles
1.
Connect the battery pack
charger
.
31
2.
Insert the mains plug into the socket. The
charging status LED
same time the green charging status LED
will extinguish. Once the battery pack
is completely charged, the green charging
status LED
is lit continuously, indicating
32
that the charging process is complete. At the
same time the red charging status LED
extinguish.
3.
Disconnect the charger
and remove the battery pack
charger.
4.
Attach the battery pack
(see "Attaching / removing the battery pack").
Charging status LEDs
Green LED flashing Charger ready
Red LED
Battery pack charging
continuously lit
Green LED
Battery pack fully charged
continuously lit
Red and green LEDs
Battery pack defect
flashing
Red and green LEDs
Battery pack too cold or
continuously lit
warm
Checking the battery charging
Q
level
Press the battery charging level button
o
check the charging level of the battery
pack
. The charging level will be shown
27
on the battery level indication light
4 Green LEDs
continuously lit
3 Green LEDs
continuously lit
2 Green LEDs
continuously lit
1 Green LED
continuously lit
1 Green LED flashing Low battery charging level
Charge the battery pack
o
when it is at medium or low battery charging
level.
27
to the battery
lights up red, at the
33
32
27
will
33
from the mains
31
from the
27
back to the product
27
28
30
.
Battery pack fully charged
Battery pack 75%
charged
Battery pack 50%
charged
Battery pack 25%
charged
27
before operation
Operation
Q
CAUTION! RISK OF INJURY!
Keep your hands away from the tool when
u
the product is in operation.
Adjusting front handle position
Q
1.
Lift and disengage the locking lever
2.
Rotate the front handle
handle
7
desired position.
3.
Press and engage the locking lever
afterward to secure the front handle
position (see Fig. H).
Adjusting pole length
Q
1.
Loosen the locking sleeve
2.
Adjust the lower pole
(see Fig. I).
3.
Tighten the locking sleeve
Adjusting trimmer head angle
Q
Adjust trimmer head
or 90° for edging.
1.
Press the unlock button
position.
2.
Rotate the trimmer head
until the unlock button
(see Fig. J).
to
Adjusting trimmer head tilt
Q
angle
Adjust tilt angle of trimmer head
ground conditions.
1.
Press the unlock button
position.
2.
Adjust the trimmer head
position until the unlock button
position (see Fig. K).
/ slide the front
7
upward or downward / to the
.
9
to the desired length
10
afterward.
9
to either 0° for trimming
17
and hold it in
11
anticlockwise
17
snaps in position
11
17
to fit the
and hold it in
12
17
to the desired
12
.
8
8
in
7
snaps in
GB / IE
33
