Ugolini MT micro Manual De Instrucciones página 22

MT micro
2
Pour the solution into the containers.
3
Using a suitable brush, wipe the solution
onto all parts above the level of the solution and
on the underside of the lid.
4
Install the lid and operate the dispenser in
order to allow the solution to be stirred for about
2 minutes. Drain the sanitising solution from the
containers through the taps and then dispose of
it.
5
Rinse using running water in order to
eliminate any remaining sanitising solution from
the bottom of the containers. Do not perform
further rinsing.
8 ROUTINE MAINTENANCE
1
Daily: inspect the machine for signs of
product leaks past seals and gaskets. If proper
assembly does not stop leaks around seals or
gaskets, check for improper lubrication, worn or
damaged parts. Replace parts as needed.
ATTENTION
Condenser fins are
extreme caution when cleaning.
2
Every month: check that the hexagonal joint
gasket is not worn. If it is, replace the joint itself
with an original spare part from the manufacturer
(see figure 16).
figure 16
3
In case of noise it needs to unplug the cooler
and call for service.
4
In case of failure unplug the machine,
because unexpected start again would be
possible.
5
It needs to fix everything back in the initial
position after any repairmen, like screws and
covers.
very sharp. Use
22
8. 1 MAINTENANCE (TO BE CARRIED
OUT BY QUALIFIED SERVICE
PERSONNEL ONLY)
1
Monthly: remove
condenser. To do this unplug the unit.
2
Annually: remove the panels and clean the
inside of the machine including the base, side
panels, condenser, etc.
3
Annually: Check if the auger bushings are
worn out or ovalized. If they are, replace them
with new ones.
4
Never remove the insulating jacket from
around the suction tubing of the evaporator (the
copper tubing located on the right side of gear
motor). In case the insulating jacket is missing
replace the entire parts with original spare parts
from the supplier.
5
In order to prevent any damages to the
dispenser, all plastics parts must be lubricated
only with grease supplied by the manufacturer or
with another lubricating product suitable for
polycarbonate.
the dust from the