Selco Genesis 60 Instrucciones De Uso página 24

4 Insufficient air pressure alarm
Indicates that the compressed air pressure is below 3.5
bar and therefore insufficient for correct operation.
5 Overtemperature alarm
Indicates that the temperature protection device has
operated.
It is advisable not to switch off the equipment while the
alarm is on; the internal fan will thus keep operating
and will help to cool the overheated parts.
6 7-segment display
Allows the general welding machine parameters to be
displayed during start-up, settings, current and voltage
readings, while welding, and encoding of the alarms.
7 Main adjustment handle
Allows the welding (cutting) current to be continuously
adjusted.
8 Measurements
Allows the real welding current or voltage to be dis-
played on 6.
Volts
Amperes
9 Air test button
Allows the compressed air circuit to be cleansed of
impurities and the carrying out of the appropriate pre-
liminary pressure and compressed air flow adjustments,
without power on.
3.3 Alarm codes
E01 Memory fault alarm
E02 Nozzle retaining cap guard alarm
E03 Air pressure alarm
E11 Temperature alarm
E12 Undervoltage alarm
E13 Overvoltage alarm
E14 General alarm
3.4 Rear panel
1 Power supply cable
Connects the system to the mains.
2 Pressure adjustment knob
3 Filter unit air connection coupling
4 Air filter unit
5 Off/On switch
Turns on the electric power to the welder.
It has two positions, "O" off, and "I" on.
24
3.5 Sockets panel
1 Torch fitting
Permits connection of the PLASMA torch.
2 Earth socket
Earth wire connector.
4 ACCESSORIES
4.1 SP101 torch
Consult the instruction manual.
5 MAINTENANCE
Routine maintenance must be carried out on the
system according to the manufacturer's instruc-
tions.
Any maintenance operation must be performed by qualified
personnel only.
When the equipment is working, all the access and operating
doors and covers must be closed and locked.
Unauthorized changes to the system are strictly forbidden.
Prevent conductive dust from accumulating near the louvers
and over them.
Disconnect the power supply before every opera-
tion!
Carry out the following periodic checks on the
power source:
- Clean the power source inside by means of
low-pressure compressed air and soft bristle
brushes.
- Check the electric connections and all the con-
nection cables.
For the maintenance or replacement of torch components,
electrode holders and/or earth cables:
Check the temperature of the component and
make sure that they are not overheated.