Selco RI2000 Instrucciones De Uso página 35

Synergetic curve selection configurations: the selection of synergetic curves is directly defined by this combination of digital
inputs.
CN3-8 Wire 9
CN3-16 Wire 8
CN11-1 Wire 52
CN11-4 Wire 55
Standard configuration
0V = 0 Input opened or not connected (low state)
24V = 1 Input closed or powered (high state)
CN11-4 CN11-1
Wire 55 Wire 52
0 0
0 0
0 0
0 0
CN3-15 Wire 7
CN3-14 Wire 6
CN3-13 Wire 5
CN3-12 Wire 4
CN3-11 Wire 3
CN3-10 Wire 2
CN3-9 Wire 1
Consult the section "Set-up parameter 400" (Genesis ... repair manual)
The combination of these digital processes is summarised in the following table:
CN3-8 CN3-16
Wire 9 Wire 8
Retrieval of synergetic curves in MIG/MAG Short Spray Arc enabled.
1 0
Retrieval of synergetic curves in Pulsed MIG/MAG enabled.
1 1
Retrieval of stored welding spots enabled (JOB).
0 1
Not used.
0 0
CODING: the combination of these digital signals makes it possible to determine the synergetic curve
or the required welding spot.
Inverted configuration
0V = 1 Input opened or not connected (low state)
24V = 0 Input closed or powered (high state)
35