Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CONNECTION AND SETUP
With the ZZONE2120PA power switched off (20), connect the rear IEC inlet (21) to the mains
using the supplied mains lead (or an equivalent approved type). Ensure that the voltage
is correct and the speaker connect is correct then power on The ZZONE2120PA has 5
input channels and an integral multi-source audio player. Microphone input 1, 2 and 3 are
designed for either microphones or line level sources (such as a CD/mp3 player or output
from a mixer) via combo connectors on the rear panel, it is switch able by DIP switch. These
can accept either XLR or 6.3mm plugs for balanced or unbalanced signals.
DIP SWITCHES
Mic/Line inputs 1, 2 and 3 each have 2 DIP switches on the rear panel to set the input level
and/or activate +48V phantom power for use with condenser microphones.
Set the level correctly for the type of input source connected (Mic or Line) If the source
connected is a condenser microphone which requires phantom power, make sure that the
phantom is switched on for that channel.
Be sure to make these DIP switch settings when the amplifier is switched off. Making any
changes when the amplifier is powered up may cause loud bangs through the system which
can damage the speakers.
PRIORITY AND EMERGENCY ACTIVATION
1. Mute input, open circuit to activate mute of highest priority and closed circuit back to
amplifier normal working status.
2. EMC input- this one is EMC audio input of secondary priority
3. Mic1 input
4. Remote microphone ZZONE6000MC
SINGNAL INPUTS AND OUTPUTS
Connect microphones or line signals to Mic/Line 1, 2 and 3 inputs using good quality signal
leads. A stereo or mono line level source can be connected to the Auxiliary channel 4 input
on 2 RCA connectors. For checking the output of any zone, an assignable Monitor output
can be connected to headphones from the front panel 6.3mm jack or as a line output (e.g.
to active speakers) from RCA connectors at the rear. Each zone output has a dedicated RCA
signal output on the rear panel, which can be connected to the line inputs of active speakers
or amplifiers. These are in addition to the speaker outputs detailed below. An antenna input
is provided on the rear panel for connection to an external aerial for FM tuning. There are
Bass and Treble volume control on rear panel to adjust the sound of MIC and Line input
signal
SPEAKER OUTPUTS
The ZZONE6000PC has a separate speaker output for each zone, connected via 3 large
modular terminal plugs. Each plug can be removed from the rear panel for convenient
connection of speaker outputs to 2 zones. Each zone output can be used to power either
100V line speakers or standard low impedance speakers. These 2 configurations cannot be
used together, so it is important to decide which will be used at the start.
5
Tabla de contenido
