Starting The Engine - Troy-Bilt 030237 Instrucciones De Uso

Section 4: Operation
OPERATmNG THE
See "Don't Overload Generator",
Start generator and Jet engine stabilize before connecting
electrical loads.
Connect electrical loads in OFF position, then turn ON for
operation.
Turn electrical loads OFF and disconnect from generator
before stopping generator.
iMPORTANT: Always unphg the battery float charger
before starting the generator.
Starting the Engine
Disconnect aH eHectrical loads from the generator. Follow
start instruction steps in numerical order:
I. Make sure unit is on a level surface.
iMPORTANT: Failure to start and operate unit on a level
surface will cause the unit not to start or shut down during
operation.
2. Follow start instructions given in engine owner's manual
and turn start switch on generator to "Start" position
(Figure 5).To prolong life of starter components, DO
NOT hold starter switch in "Start" position for more
than 15 seconds, and pause for I minute.
WARNING
DO NOT touch hot surfaces.
Allow equipment to cool before touching.
The generator must be at least S feet from structures having
combustible walls and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of generator for
adequate cooling, maintenance and servicing.
In the State of California
a spark attester
is required by law
(Section 4442 of the California Public Resources Code). Other
states may have similar Jaws. Federal laws apply on federal
lands. [f you equip the muffler with a spark arrester, it must be
maintained in effective working order:
Jump_ Start
Procedure
Jf generator's starting battery fails, use following instructions
to iump start generator.You can iump start generator using
any 12Volt automotive or utility style storage battery.
I. Unscrew fuse holder and remove generator's 10Amp
indine fuse (Figure 6t.Verify fuse is good or replace
with a known good fuse. Reinstall fuse in fuse holder.
2, Slide red rubber boot off generator's battery terminal
and push it onto red wire, thus uncovering POSITIVE
battery terminal,
3, Using standard automotive iumper cables, connect
RED iumper cable clamp to generator's POSITIVE
battery terminal (Figure 7),