Troy-Bilt 030237 Instrucciones De Uso página 8

Operation
USmNG THE GENERATOR
System Ground
The generator has a system ground that connects the
generator frame components to the ground terminals on
the AC
output
receptacles.The system ground is connected
to the AC neutral wire (see "Equipment Description'_
earlier in this manual).
Special Requirements
There may be Federal or State Occupational Safety and
Health Administration (OSHA) regu[ations_ local codes, or
ordinances that apply to the intended use of the generator.
Please consuk a qualified e[ectriciam electrical inspector, or
the local agency having jurisdiction.
o In some areas_generators are required to be registered
with local utility companies.
o If the generator is used at a construction site, there may
be additional regulations which must be observed.
Connecting to a Build[rig's Electrical
Connections for standby power to a bui[ding's electrical
system must be made by a qualified electrician.The
connection must isolate the generator power from utility
power, and must comply with a[[ applicable laws and
electrical codes.
WARNING
When using generator for backup power; notify utility
company. Use approved transfer equipment to isolate
generator from electric utility:
Use a ground fauk circuit interrupter (GFCI) in any damp or
highly conductive area, such as metal decking or steel work.
DO NOT touch bare wires or receptacles
DO NOT use generator with electrical cords which are worn,
frayed, bare or otherwise damaged.
DO NOT operate generator in the rain.
DO NOT handle generator or electrical cords while standing
in water, while barefoot, or while hands or feet are wet.
DO NOT allow unqualified persons or children to operate or
service generator:
Operate generator ONLY outdoors.
Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
DO NOT operate generator inside any building or endosure_
including the generator compartment of a _creatJonal vehicle (RV).
The generator must be at [east 5 ft. ([ 52 cm) from
structures having combustible wails and/or other
combustible materials. Leave at [east 3 ft. (92 cm) a[[ around
generator including overhead_ for adequate coo[ing_
maintenance and servicing.
Place generator in a we[[ ventilated area, which wi[[ allow
for removal of deadly exhaust gas. DO NOT place
generator where exhaust gas could accumulate and enter
inside or be drawn into a potentially occupied building.
Ensure exhaust gas is kept away from any windows_ doors_
ventilation intakes or other openings that can allow exhaust
gas to collect in a confined area (Figure 4). Prevailing winds
and air currents should be taken into consideration when
positioning generator.
Exhaust Port