Comet VR 10 Manual De Instrucciones página 22

CAUTION
• If the identification plate should be damaged during use, contact your authorised dealer or service centre
to get it restored.
CAUTION
• The control unit is exclusively intended for the following uses:
- protection treatments of agricultural and gardening crops;
- pumping of detergents and colours in water solution (not inflammable);
- pumping water not intended for human consumption.
• The control unit is the necessary complement of the pump incorporated in the machine on which it is
installed.
The restrictions of use provided for the pump in the use and maintenance manual also apply to
this control unit; these use restrictions are fully reported in this document.
Any different use should be considered improper.
The Manufacturer cannot be held liable for damages arising from an improper or incorrect use.
CAUTION
• The installation of the control unit must be carried out by a Specialised technician.
• Before using the control unit, read carefully the instructions contained in this manual, in the pump manual to which
the control unit is connected and in the machine manual onto which the control unit is installed. In particular make
sure you have well understood how the control unit works as far as the liquid shut-off operations are concerned.
• Do not operate any tap fitted onto the control unit if they are not connected to an accessory (lance, herbicidal
bar, etc.) which prevents the pumped liquid from exiting accidentally.
• Observe the safety warnings contained in the use and maintenance manual of the pump to which the
control unit is connected and of the machine onto which it is installed.
• The control unit is the necessary complement of the pump incorporated in the machine on which it is
installed.
The safety warnings provided for the pump in the relative use and maintenance manual also
apply to this control unit; these warnings are fully reported in this document.
• Comply with the instructions contained in paragraph
• The working pressure must never exceed the maximum value provided for the control unit (also refer to
paragraph
"TECHNICAL FEATURES AND DATA"
• Do not use the control unit if:
- it has been knocked seriously;
- there are evident water leaks.
In such cases have a Specialised technician check the control unit.
• Check that all hooks (11) on the control unit are correctly fitted. Pay special attention to those control units
which are fastened to the pump or to the remote control kit by means of a hook.
• Do not change in any way the installation conditions of the control unit, in particular do not change its
fastening and hydraulic connections.
• Do not carry out any maintenance job on the control unit if the machine on which it is installed is working.
• Ask a Specialised technician to carry out the checks scheduled by Extraordinary Maintenance.
22
INTENDED USE
OPERATION
"INTENDED USE"
).
.