16. Plug into mains and twist On/Off control dial to On.
17. The blue light will illuminate to indicate power on. The green light
will illuminate to indicate the steamer is ready to use.
18. To steam your floors with detergent burn the dial to ON and without
detergent turn the dial to Off.
19. Place your foot onto the floorhead and pull handle backwards to
recline.
20. To produce steam squeeze the trigger in short bursts. Don't hold
the trigger continuously to prevent over wetting floors.
21. Move the steamer slowly backwards and forwards across the floor
paying particular attention to high traffic areas. Squeeze/release
trigger as required.
22. Hold corner of pad down with your foot and lift steamer to peel
away.
CAUTION: Always switch OFF the steamer when fitting the
microfiber cleaning pads.
REFRESHING CARPETS
IMPORTANT: When using on carpets, always make sure the
microfiber cleaning pad is used and covers the floorhead entirely
before using the carpet glider. Only use the carpet glider when
refreshing carpets and turn the detergent dial to Off.
