Idiomas disponibles
Idiomas disponibles
RRW 500 800 1000 1300 1500 1800
How to mount the heater
Always respect the minimum dimensions shown in the last picture on the next page.
1. After selecting the location to install the thermal emitter, place an upper support vertically on the
wall and mark the two holes with a spacing of 30 mm. Once done, and depending on its thermal
emitter, choose the distance D1 with respect to the previous signals (Fig 3)
Model
RRW 500
RRW 800
RRW 1000
RRW 1300
RRW 1500
RRW 1800
2. Make four holes, insert wall plugs and screw the upper brackets to the wall (Fig 4)
3. Screw the bottom to the bottom of the emitter.
4. Hang the thermal emitter and mark the point to be drilled bottom bracket (Fig 5).
5. Lift the transmitter and make the hole.
6. Hang transmitter again and screw the bottom bracket to the wall so that the sender is completely
fixed (Fig 6)
Mounting dimensions
(D1)
155 mm
155 mm
155 mm
155 mm
386 mm
542 mm
Fig.2
31
