Control Connections - WEG CFW300 Manual Del Usuario

Installation and Connection

3.2.5 Control Connections

The control connections must be made in accordance with the specification of the connector
of the CFW300 control board. Functions and typical connections are presented in
page
22. For further details on the specifications of the connector signals, refer to
8 TECHNICAL SPECIFICATIONS on page
1 2 3 4 5 6
(+) AI1 (-)
(0 to 20) mA
(4 to 20) mA
(a) NPN Configuration
1 2 3 4 5 6
24 V
(+) AI1 (-)
(0 to 20) mA
(External supply)
(4 to 20) mA
(b) PNP Configuration
NOTE!
The CFW300 inverters are supplied with the digital inputs configures as active
„
low (NPN). In order to change the configuration, check the use of parameter
P271 in the programming manual of the CFW300.
Analog input AI1 is set for input 0 to 10 V, in order to change, check parameter
„
P233 of the programming manual.
For the correct connection of the control, use:
1. Gauge of the cables: 0.5 mm² (20 AWG) to 1.5 mm² (14 AWG).
2. Maximum torque: 0.4 N.m (3.54 lbf.in).
3. Wiring of the connector of the control board with shielded cable and separated from the
other wiring (power, command in 110 V / 220 Vac, etc.), according to
Separation Distance on page
in perpendicularly among them, keeping the minimum separation distance of 5 cm at the
crossing point. Connect the shield according to the
22 | CFW300
38.
7 8 9 10 11 12
AI1
(0 to 10) V
7 8 9 10 11 12
AI1
(0 to 10) V
Figure 3.3: (a) and (b) Signals of C300 control card connector
23. If those cables must cross other cables, it must be done
Connector
1 DI1 Digital input 1
2 DI2 Digital input 2
3 DI3 Digital input 3
4 DI4 Digital input 4
5 GND Reference 0 V
6 AI1 Analog input 1
(Current)
7 GND Reference 0 V
8 AI1 Analog input 1
(Voltage)
9 +10 V Reference +10 Vdc
for potentiometer
10 DO1-RL-NC Digital output 1
(NC contact of relay 1)
11 DO1-RL-C Digital output 1
(Common point of relay 1)
12 DO1-RL-NO Digital output 1
(NO contact of relay 1)
(*) For further information, refer to the detailed specification in
Section 8.2 ELECTRONICS/GENERAL DATA on page
Figure 3.4 on page
Figure 3.3 on
Chapter
Description
(*)
39.
Item 3.2.6 Cable
23.