LED Function and Response Table
Function
Unit is ON
Low battery condition
Delivering vibration
Test Mode
To Test the Vibration Bark Control Collar
1.
Begin with the Collar in the "OFF" position.
2.
Turn to the "ON" position until the LED shows Orange.
3.
Immediately turn to the "OFF" position after seeing the Orange LED.
4.
Turn to the "ON" position. The LED will flash Orange and you are now in
test mode.
5.
Blow into the microphone and the Orange LED will flash to indicate that the
microphone is working.
6.
Scratch lightly between the Vibration Points to indicate the vibration is working.
7.
If the LED light does not flash and there is no vibration, ensure that the battery
is properly installed and/or replace the battery. If there is still no response,
contact the Customer Care Centre.
8.
Turn "OFF" to end the test mode. The test mode will also time out after 30
seconds and resume normal operation.
What to Expect During Use of the Vibration
Bark Control Collar
Important: Do not leave your dog alone the first few times he receives
a Vibration Stimulation.
Place the Bark Control Collar properly on your dog and wait nearby until he barks.
Most dogs will understand very quickly that the Bark Control Collar is disrupting their
urge to bark and will relax and stop barking. Because the Vibration Stimulation from
the Bark Control Collar may be surprising or startling at first, some dogs may bark
more at the initial stimulation.
On rare occasions, a dog may get into a bark-stimulation-bark-stimulation cycle.
If this happens, reassure your dog with calm, soothing tones. As your dog relaxes,
he will understand that if he becomes quiet, he will not receive any more Vibration
Stimulations. The small minority of dogs that have this reaction will only have it the
first time they wear the Bark Control Collar.
LED Light Response
Green LED Light flashes once every 5 seconds
Red LED Light flashes 3 times every 5 seconds
Red LED Light flashes for each stimulation
Orange LED flashes
petsafe.com
9