Error Code Display - Gianni Ferrari PG210 Manual Tecnico

20. Error CodE disPLAy

ERROR ERROR BUZZER
POSITION CODE
Initial test E1 lamp
phase
E2 lamp
E3 lamp
E4 lamp
Glow plug E10
heating cycle
E11
E12
E14
Operating E20
cycle
E21
E22
E24
Lamp Beeps
temp.
E30 Very
slow
beeps
E31 Slow
beeps
Any phase CC1
CC2
CC3
ALARM POSSIBLE CAUSES
DESCRIPTION AND/OR REMEDIES
The test on the pre-heating sensor The pre-heating sensor has
has detected a lower temperature probably not been activated
than the envisaged range. correctly.
The test on the pre-heating sensor The pre-heating sensor has
has detected a lower temperature probably not been activated
than the envisaged range. correctly.
The test on the water temperat- The water temperature sensor Until the error condition
ure sensor has detected a higher has probably not been activ-
temperature than the range. ated correctly.
The test on the water temperat- The water temperature sensor Until the error condition
ure sensor has detected a lower has probably not been activ-
temperature than the range. ated correctly.
The safety test has found the Disconnect the PTO.
PTO activated.
The safety test has found the Apply the parking brake.
parking brake is off.
The safety test has found the The driver must sit on the
driver is not in his seat. seat.
The safety test has found the Close the engine compartment. Until the error condition
engine compartment open.
The safety test has found the Disconnect the PTO.
PTO activated.
The safety test has found the Apply the parking brake.
parking brake is off.
The safety test has found the Sit on the seat.
man is not in his seat.
The safety test has found the Close the engine compartment. Until the error condition
engine compartment open.
The water temperature test has Disengage PTO and keep
found that the engine has motor at medium speed.
exceeded the temperature of
100°C.
The basket is full and the PTO
activated.
The air filter is clogged.
There is a short circuit on the Check the glow plug heating
glow plug heating output. circuit.
There is a short circuit on the Check the engine stop
engine stop output. circuit.
There is a short circuit on the Check the buzzer circuit.
buzzer output.
LENGTH OF
ERROR
SIGNAL
Until the error condition 1
is removed.
Until the error condition 1
is removed.
2
is removed.
2
is removed.
Until the error condition 1
is removed.
Until the error condition 2
is removed.
Until the error condition 3
is removed.
5
is removed.
Until the error condition 1
is removed and the engine
switched back on.
Until the error condition 2
is removed and the engine
switched back on.
Until the error condition 3
is removed and the engine
switched back on.
5
is removed and the engine
switched back on.
Until temperature 6
returns normal.
Until you quit the alarm 7
condition.
Until you quit the alarm 7
condition.
Until the error condition 0
is removed and the engine
switched back on.
Until the error condition 0
is removed and the engine
switched back on.
Until the error condition 0
is removed and the engine
switched back on.
EN
33