Makita DUC307 Manual De Instrucciones página 11

9. Place the sprocket cover on the chain saw so that
the adjusting pin is positioned in a small hole on the
guide bar.
3
Fig.12
► 1. Sprocket cover 2. Guide bar 3. Hole
10. Turn the lever clockwise fully and turn back the
lever a little to keep looseness for adjusting the chain
tension.
11. Adjust the chain tension. Refer to the section for
adjusting saw chain tension for procedure.
12. Turn the lever clockwise until the sprocket cover is
secured then return it to the original position.
Fig.13
► 1. Lever 2. Sprocket cover
Removing the saw chain
To remove the saw chain, perform the following steps:
1.
guard.
1
2.
the saw chain tension.
2
Fig.14
► 1. Adjusting dial
3.
1
Fig.15
2
► 1. Lever
4.
cover comes off.
Fig.16
► 1. Lever 2. Sprocket cover
5.
chain and guide bar from the chain saw body.
11 ENGLISH
Release the chain brake by pulling the front hand
Turn the adjusting dial to "-" direction to release
1
Pull the lever up while pressing its edge.
Turn the lever counterclockwise until the sprocket
Remove the sprocket cover then remove the saw
1
1
2