SICK HSE18L Manual De Instrucciones página 51

1.8.3 Setting
8017854.1HW2/2022-11-14 | SICK
Subject to change without notice
If several through-beam photoelectric sensors which are installed next to one another
are to be used, we recommend swapping the sender/receiver arrangement at every
second through-beam photoelectric sensor and ensuring that there is sufficient dis‐
tance between the through-beam photoelectric sensors. By doing this, mutual interfer‐
ence can be prevented [see
Table 25: Operating reserve
Operating reserve
1,000
100
10
1
0 5 10
(16.40) (32.81) (49.21)
Figure 18: HSE18, Redlight
Operating reserve
10,000
1,000
100
10
1
0
10 20 30
(32.81) (65.62) (65.62)
Figure 20: HSE18L
Sensitivity setting
Sensor which it is not possible to set: The sensor is adjusted and ready for operation.
Refer to graphic to check the function. If the switching output fails to behave in accord‐
ance with graphic, check application conditions. See section Fault diagnosis.
Sensor with potentiometer (without IO Link):
The sensitivity is adjusted with the potentiometer (type: 270°). Clockwise rotation:
operating reserve increased; counterclockwise rotation: operating reserve reduced. We recommend setting the potentiometer to "Maximum".
Sensor with potentiometer (IO Link):
figure 12].
Operating reserve
1,000
100
10
1
15 20 25 0
(65.62) (82.02)
Distance in m (feet)
Figure 19: HSE18L, Infrared light
40 50 60
(131.23) (164.04) (196.85)
Distance in m (feet)
O P E R A T I N G I N S T R U C T I O N | HSE18(L)
OPERATING INSTRUCTION
5 10 15 20
(16.40) (32.81) (49.21) (65.62)
Distance in m (feet)
25
(82.02)
51