Idiomas disponibles
Idiomas disponibles
Operation
Information on mowing
Do not mow wet grass. Drive slowly at
maximum engine speed. When adjusting the
cutting height and travel speed, ensure that
the device is not overloaded. Depending on
the length, type, and dampness of the grass,
adjust the cutting height and driving speed in
order to be able to collect grass with a grass
catcher without any trouble.
In the event of blockages, reduce speed and
raise the cutting height.
Note on the PTO switch
In the case of automatic shutdown through
the safety locking system (e.g. reversing
with the cutting mechanism activated), first
switch the switch off, and then back on
again, to release the clutch lock.
OCR (reverse mowing mode) function (mod-
el-dependent) C
The ignition lock is fitted with an OCR function,
which offers you user-controlled mowing, even when
reversing.
Start the engine.
Î
Turn the ignition key [3] anti-clockwise from
Î
normal position to reverse-mowing position
and press switch [1].
3 Indicator lamp [2] comes on. You can now mow
both when moving forwards and when reversing.
To end the OCR function, turn the ignition switch
Î
to the right to the normal position
3 Indicator lamp [2] goes out.
Notes
The OCR function is switched off automat-
ically once the key is turned to the normal
position or the engine is switched off (stop
position or switching off of the engine via the
safety locking system).
Tips on lawn care
Mowing
A lawn is made up of various different types of grass. If you
mow more frequently, the grown of strongly-rooting grasses
is favoured resulting in firm turf. If you seldom cut the
grass, you will enhance the development of high-growing
types of grass and other weeds (e.g. clover, daisies ...).
The normal height of a lawn is approx. 4–5 cm. Only
1/3 of the total height should be mown; therefore
cut 7–8 cm long grass to normal height. Preferably
do not cut the lawn shorter than 4 cm, otherwise the
turf will be damaged in a dry period. If the grass has
grown particularly high (e.g. during a holiday period),
cut it back to its normal height in stages.
Mulching using the accessories (optional)
With mulching, the grass is cut into small pieces
(approx. 1 cm) during mowing and is left on the
ground. A lot of the nutrients in the cut grass are
retained for the benefit of the lawn.
Ask your specialist dealer for appropriate mulching
Î
accessories.
Note
This device is designed to mow lawns. Do
not mow scrub, weeds, or overlong grass.
Pay attention to the following notes:
• Do not mow wet grass.
• Never cut more than 2 cm of the total grass
length.
• Drive slowly and at maximum engine speed.
• Clean the cutter deck regularly.
Switching the device off
Stop the device.
Î
Switch the cutter deck off.
Î
Set the throttle to
Î
Bring the cutter deck to the top position.
Î
Switch the engine off after 60 seconds.
Î
Switch the parking brake on.
Î
Close the fuel tap (if present, see engine manual).
Î
Remove the ignition key.
Î
Pushing the device L
.
Switch the engine off.
Î
Switch the parking brake off.
Î
Pull the gear release lever [A] back and then to
Î
the right until it sits in the recess 12 .
3 You can now push the device.
Note
Never tow the device. This can cause seri-
ous damage to the gears.
To continue driving, pull the gear release lever [A]
Î
to the rear left out of the recess and then press it
fully forward.
.
EN
19
