Idiomas disponibles
Idiomas disponibles
Operation
To switch the parking brake off, press the lever
Î
[A] to the right out of the recess and push it fully
forward until the lever engages in position
Note
Before switching the parking brake on,
always bring the device to a stop before
doing so, and do not press the accelerator
pedal any more.
Do not press the accelerator pedal again
once the parking brake is switched on
because this could result in damage to the
gearbox.
Attention!
¾ Always switch on the parking brake before
leaving the device.
Setting the engine speed D
You can set the engine speed with infinite variability
using the throttle.
Fast engine speed =
Slow engine speed =
Starting the engine C D E
Note
The choke E is used to start the device
when the engine is cold. Some models have
no choke. The engine is automatically set
to the particular starting process. Follow the
separate information in the engine operating
instructions.
Open the fuel tap (if present, see engine manual).
Î
Sit down on the driver's seat.
Î
Switch the parking brake on.
Î
Switch the cutter deck off.
Î
Insert the ignition key into the ignition lock.
Î
Turn the ignition key to
Î
minute to fill the engine fuel system with fuel. Then
turn the ignition key back to
This action step is only necessary for devices with
an electronic throttle - see also the engine oper-
ating instructions.
Set the throttle to the middle position between
Î
and
.
Note
On some models this position is also marked
with "START".
If the engine is cold, pull out the choke or set the
Î
throttle to
(only required for devices fitted with a
choke system).
Turn the ignition key [3]:
Î
Turn the ignition key to
Î
starts running.
Release the ignition key.
Î
3 The ignition key remains in the normal position
/
.
/
/ON for about one
/OFF.
until the engine
Note
A start attempt should take a maximum of 5 sec-
.
onds. Wait 10 seconds before trying again.
Note
The OCR function must not be activated
during the start process (see section "OCR
function").
Reset the choke / throttle slowly until the engine is
Î
running smoothly.
Note
On devices with an electronic throttle and
fully electronic fuel injection system, a
metallic ticking may be heard when starting
the engine. Let the engine run in the starting
position for five to ten minutes.
If the noise can still be heard, switch off the
engine and contact a specialist workshop.
Stopping the engine C D
Set the throttle to
Î
Let the engine run for about 60 seconds.
Î
Set the ignition key to
Î
Remove the ignition key.
Î
Switch the parking brake on.
Î
Driving M
Risk posed by abrupt starting, sudden stop-
ping and driving at an excessively high speed.
ÂRisk of accidents
¾ Drive slowly and brake slowly.
¾ Do not drive at excessive speed.
¾ Be particularly careful when reversing.
¾ Never change the direction of travel with-
out first bringing the unit to a standstill.
¾ When entering corners, always reduce
your speed and adjust the speed to the
turning radius (the tighter the corner, the
lower the speed).
¾ Never adjust the steering column or the
driver's seat when in motion.
¾ Never operate the device without the
cutter deck.
Additional safety information on the drive
If the device is moving slightly (crawling),
even though you are not pressing the accel-
erator pedals
(= neutral position), switch the device off, dis-
continue use and take it to a service centre.
Note
Do not step on the forward or reverse pedal
while you are activating the brake pedal or
the parking brake is switched on. This may
damage the gearbox.
.
.
WARNING!
EN
17
