Idiomas disponibles
Idiomas disponibles
- ACCESS: allows you to modify the password to access the matrix and lock/unlock the buttons on the front
panel of the matrix.
VIA RS-232 COMMUNICATION
To configure the equipment using the RS-232 port, connect the cable as
follows:
Use a suitable program for communication via RS-232 protocol and perform the following configuration:
- Select the COM port used on your PC for this communication
- Baud rate: 9600
- Data bits: 8
- Parity: ninguna
- Stop bits: 1
Here are the commands for RS-232 communication.
Note: Note that the symbols "[" and "]" are used below to make the command easier to understand and
should not be used when typing the command.
COMMAND
PowerON.
PowerOFF.
/*Name.
/*Type.
/^Version.
RST.
DS[XX]ON.
DS[XX]OFF.
OUT[XX]:[YY].
Turn on the matrix
Turn off the matrix
Matrix name
Matrix model
Firmware version
Restore factory settings
Activate/deactivate the down-scaling function
[XX]: 01-04 (output 5~8)
00 (all outputs from 5 to 8)
Assign input signal [YY] to output [XX]
[XX]: 00 (all outputs from 1 to 8)
01-08 (output 1-8)
[YY]: 01-08 (input 1-8)
FUNCTION
- 9 -
EN
