FONESTAR FO-22M88 Manual De Instrucciones página 5

VIA TCP/IP COMMUNICATION - GUI
Connect the matrix to a PC using a Cat 5e/6 cable.
The default parameters of the FO-22M88 matrix are as follows:
- IP direction: 192.168.0.178
- Subnet mask: 255.255.255.0
- Default gateway: 192.168.0.1
Configure the PC in the same range as the matrix to operate
the equipment through the TCP/IP communication protocol.
To do this, go to the properties of your network card and
configure a set IP (within the same network as the matrix).
Once the PC has been configured, you can enter the IP address of the matrix (192.168.0.178) in the browser
to be able to connect to it. You will be prompted to enter a user name and password:
- User name: admin
- Password: admin
At this point, the matrix will be connected to the PC and you will be able to control the operation of the matrix
using the menu shown below:
There are 8 tabs on the screen for configuring the matrix FO-22M88, which make it very intuitive to work via
TCP/IP:
- SWITCHING: allows the assignment of inputs and outputs via matrix buttons.
It also allows you to save and retrieve up to 6 saved configurations (PRESETS). To save a PRESET,
press SAVE, to load a previously saved PRESET press RECALL.
- 5 -
EN