Idiomas disponibles
Idiomas disponibles
Do not throw old equipment away with household
waste!
This symbol indicates that this product must
not be disposed of in household waste as per
Waste Electrical and Electronic Equipment di-
rective (2012/19/EU) and national laws. This
product must be handed over at the intended
collection point. This can be done, for example, by
returning it when purchasing a similar product or de-
livering it to an authorised collection point for the re-
cycling of old electrical and electronic devices. Im-
proper handling of old devices can have negative
effects on the environment and on human health due
to potential hazardous materials which are often con-
tained in old electrical and electronic devices. By dis-
posing of this product properly, you are also contrib-
uting to the effective use of natural resources.
Information about collection points for old devices can
be found at your municipal authority, the local dispos-
al provider, an authorised location for the disposal of
old electrical and electronic devices or your waste col-
lection service.
16. Trouble shooting
Warning: Switch the machine OFF and remove the mains plug from the power outlet.
Fault
The axis returns to its starting
position too quickly or too slowly
The chuck keeps loosening
from the spindle despite being
reattached.
High noise level during oper-
ation
The wood splits on the drill bit's
outlet opening
Problem
The spring pre-tension is set
incorrectly.
Dirt, grease or oil on the spindle or
on the inside of the chuck.
Incorrect V-belt tension.
The spindle is too dry.
The pulley on the spindle is loose.
The pulley on the motor is loose.
There is no suitable base under-
neath the workpiece.
www.scheppach.com
Solution
Setting the spring tension, see also
"Spindle return spring".
Use a household detergent to clean the
surface of the spindle and chuck. See
also "Installing the chuck"
Set the V-belt tension again. See also
"Setting the speed and V-belt tension".
Test the spindle. See also "Lubrication".
Check that the nuts on the pulley are
tight and re-tighten if necessary.
Tighten the set screw on the motor
pulley.
Use a suitable base. See also "Adjust-
ing the table and the workpiece".
GB | 37
