Parkside PDLS 5 A1 Traduccion Del Manual De Instrucciones Originales página 35

Switching on:
♦ To switch on, pull the trigger on the air paint
spray gun and keep it pressed in .
Switching off:
♦ To stop working, simply release the trigger on
the air paint spray gun
Setting the paint volume
You can regulate the paint quantity which is sprayed
using the paint volume regulating screw
♦ Work out the best settings by carrying out a
test .
Setting the paint jet pattern
The appliance has two settings: round jet and
broad jet .
Round jet
■ Use the round jet for small surfaces, corners
and edges .
■ You can use the broad jet vertically or horizon-
tally for larger surfaces .
♦ Turn the regulator
type has been set .
♦ Work out the best settings by carrying out a
test .
Replacing the nozzle
♦ Screw off the paint volume regulating screw
by turning it in an anticlockwise direction .
♦ Remove the nozzle needle .
♦ Unscrew the union nut
nozzle head .
♦ You can now unscrew the nozzle using a hex
key .
♦ Reassemble the appliance in reverse order .
■ 32 │ GB │ MT
All manuals and user guides at all-guides.com
.
.
Broad jet
until the desired spray
together with the
Maintenance
WARNING! RISK OF INJURY!
Disconnect the tool from the
compressed air supply.
♦ Clean the appliance after every use .
WARNING – PROPERTY DAMAGE!
► Never submerse the appliance completely in
cleansing agents, otherwise the seals can be
damaged .
► Do not use any hydrocarbon-based solvents
like benzene, ethyl chloride, etc ., as these
could trigger chemical reactions with some of
the materials in the air paint spray gun . This
can lead to dangerous reactions .
♦ Rinse the air paint spray gun out using a
container filled with a suitable cleansing agent
at low pressure .
♦ Collect the liquid in a container and dispose of
the liquid in an environmentally correct manner .
♦ Oil the moving parts on the trigger of the air
paint spray gun .
♦ If you remove the nozzle during cleaning you
must grease it afterwards . Do not use any
silicon-based lubricants .
Operating the air blow gun
Switching on:
♦ To switch on, pull the trigger on the air blow
gun and keep it pressed in .
Switching off:
♦ To stop working, simply release the trigger on
the air blow gun .
PDLS 5 A1