Machine Setup; Attaching Squeegee Assembly; Installing Brush/Pad - Tennant T3 Manual De Operador Y Lista De Repuestos

MACHINE SETUP

ATTACHING SQUEEGEE ASSEMBLY

1. Park the machine on a level surface and remove
the key.
2. Lift the squeegee lift lever to the upward position
(Figure 4).
FIG. 4
3. Mount the squeegee assembly to the squeegee
pivot bracket as shown (Figure 5). Make sure the
knobs are completely seated into the slots before
securing knobs.
FIG. 5
4. Connect the vacuum hose to the squeegee
assembly. Loop the hose as shown using the hose
clip provided (Figure 6).
FIG. 6
5. Check the squeegee blades for proper adjustment
(See SQUEEGEE BLADE ADJUSTMENT).
Tennant T3 (04- -05)
Home Find... Go To..

INSTALLING BRUSH/PAD

NOTE: Refer to the BRUSH AND PAD
INFORMATION section in this manual or consult your
authorized distributor for brush and pad
recommendations.
1. Park the machine on a level surface and remove
the key.
2. Step down on the scrub head lift pedal to raise the
scrub head off the floor (Figure 7).
FIG. 7
3. Attach the pad to the pad driver before installing
the driver (Figure 8). Secure pad with centerlock.
FIG. 8
4. Align the pad driver/brush mounting studs into the
motor hub slots and give it a quick counter--
clockwise turn towards the spring clip (Figure 9).
Spring Clip
FIG. 9
5. To remove a pad driver or brush, simply give it a
quick turn away from the spring clip.
OPERATION
9