Edesa EGG-6030 TI B Manual De Instrucciones página 22

Check periodically the state of conservation of the flexible gas feed pipe. In case of leakage, call
immediately the qualified technicians for its replacement.
Maintenance vitroceramic surface
(Fig.-2) First of all remove stray food bits and grease drops from the cooking surface with the special
scraper (fig. 2). Then clean the hot area as best as possible with SIDOL, STAHLFIX or other similar products
with a papertowel, then rinse again with water and dry with a clean cloth.
Pieces of aluminum foil and plastic material which have inadvertently melted or sugar remains or highly
sacchariferous food have to be removed immediately from the hot cooking area with the special scraper
(fig. 2). This is to avoid any possible damage to the surface of the top.
Under no circumstances should abrasive sponges or irritating chemical detergents be used such as oven
sprays or spot removers.
Do not use steam cleaning appliances to clean the cooking surface.
Fig. 2
INSTRUCTIONS FOR THE INSTALLER
Installation
This appliance is not provided with a combustion product discharge. It is recommended that it be installed
in sufficiently aerated places, in terms of the laws in force. The quantity of air which is necessary for
combustion must not he below 2.0 m /h for each kW of installed power.
3
See table of burner power.
Positioning
The appliance can be fitted into a working area as illustrated on the corresponding figure. Before
positioning the hob, fit the seal around the entire peripnery of the hole cut in the worktop.
22