Edesa EGG-6030 TI B Manual De Instrucciones página 20

INSTRUCTIONS FOR USE
Installation
All the operations concerned with the installation (electrical connection) must be carried out by qualified
technicians, in terms with the standards in force, for specific instructions, kindly read the part reserved for
the installation technician.
Use
Gas burners (fig. 1).
The ignition of the gas burner is carried out by putting a small flame to the upper part holes of the burner,
pressing and rotating the corresponding knob in an anti-clockwise manner, until the maximum position
has coincided with the marker. When the gas burner has been turned on, adjust the flame according to
need. The minimum position is found at the end of the anti-clockwise rotation direction.
In models with automatic ignition, operate the knob as described above, pressing simultaneously, the
corresponding push-button. For models with automatic/simultaneous (with one hand) ignition, it is
sufficient to proceed as described above using the corresponding knob. The electric, spark, between the
ignition plug and the burner provides the ignition of the burner itself After ignition, immediately release the
push-button and adjust the flame according to need.
For models with a thermoelectric safety system, the burner is ignited as in the various cases described
above, keeping the knob fully pressed on the maximum position for approximately 3/5 seconds. After
releasing the knob, make sure the burner is actually lit.
N.B.: - we recommend the use of pots and pans with a diameter matching that of the burner, thus
preventing the flame from escaping from the bottom part and surrounding the pot
- do not leave any empty pots or pans on the fire
- do not use any tools for grill-cooking on Crystal hobs.
When cooking is finished, it is also a good norm to close the main gas pipe tap and/or cylinder.
GAS
* with reduction grid
Fig. 1
fast Ф 20 x 26
semifast Ф 14 x 20
auxiliary Ф 10 x 14
fish*
20
20 x 32