Pulsar AXION F Guia De Inicio Rapido página 10

ENG
Getting Started
Before first use, the battery
y
according to the diagram in the figure.
Insert the battery
y
device's casing (10), aligning the images to form a 'dot'
on the device (A) and the battery (B). When properly
installed, the battery is locked into the slot with a special
clip.
Remove the lens cover (7). Secure the cover to the strap
y
using the magnet built into the cover.
Turn the device on with a short press of the ON/OFF
y
button (5).
Adjust the resolution of the icons on the display by
y
rotating the diopter adjustment ring on the eyepiece (1).
To focus on the object under observation, rotate the lens
y
focus ring (6).
Select the desired calibration mode in the main menu:
y
Manual (M), Semi-automatic (SA) or Automatic (A).
Calibrate the image with a short press of the ON/OFF
y
button (5) (where calibration mode SA or M has been
selected). Close the lens cap before manual calibration.
Select the required amplification level ("Normal", "High",
y
"Ultra") by briefly pressing the UP button (4).
Activate the quick menu by briefly pressing the MENU
y
button (3) to adjust the brightness, contrast and smooth
digital zoom of the display.
10 Quick Start Guide
(11) should be charged
(11) into the assigned slot on the
Turn the device off with a long press of the ON/OFF
y
button (5).
Button Operation
(5) ON/OFF button
Device is off: Power on the device: short press of the
ON/OFF button (5).
Device is on: Power off the device: long press of the
ON/OFF button
seconds.
Turn display off: long press of the ON/OFF
button (5) for less than 3 seconds.
Turn display on: short press of the ON/
OFF button (5).
Microbolometer calibration: short press of
the ON/OFF button (5).
(2) DOWN/REC button
Device is in
Start /pause/resume video recording:
Video mode:
short press of the DOWN/REC button (2).
Stop video recording: long press of the
Device is in
DOWN/REC button (2).
Video mode:
(5) for longer than 3