Idiomas disponibles
Idiomas disponibles
Return to REMOTE IP. This can be done in several ways:
-
o
Press the button again for 10 seconds.
By time. The charger automatically switches to REMOTE IP after 20 minutes in LOCAL IP
o
mode.
5.7
TEMPERATURE SENSOR
The EPS-120-5192 and EPS-200-5193 chargers incorporate a pre-wired temperature sensor to measure the
ambient temperature near the batteries, in order to optimise their life.
By compensating the output voltage with the temperature, these chargers maximize the life of the batteries
used.
The characteristics of the sensor are shown below:
Dimensions
Operating temperature
Storage temperature
Wiring length
Note 1: It will be possible to supply the sensor pre-wired in other lengths upon request:
Standard 5m and 10m sizes available.
5.8
CONFIGURATION:
The charger parameters can be configured using an XML configuration file and/or a web browser. However,
the parameters can only be modified within the range established for each of them.
5.9
COMMUNICATIONS:
The EPS-120-5192 and EPS-200-5193 chargers have an Ethernet port for communications.
The charger has a Web interface that allows you to look up the output voltage, the power consumed at the
output, detailed alarms, the configuration of the device, the firmware loaded, the status of the batteries etc.
The device allows configurations to be loaded using an XML configuration file and/or by changing parameters,
using a generic web browser (for more details, see the device's communications operating manual).
www.premiumpsu.com
Powering Your Challenge
Figure 12. Push button and LEDs.
CHARACTERISTICS
39 x 16 x 2 mm (Width x Height x Depth)
-40 to 80 ºC
-40 to 80 ºC
2 metres (maximum: 10m)
Serie EPS
Manual de Operación
1
MA-5192A-1
20-10-2021
17 / 84
