ASSEMBLE THE FRAME
Note: The combination of vanities used in your installation may visually vary from the images shown. For reference, an H1 False Front
frame over an H2 Drawer frame is shown in the following steps.
1. Arrange the Vanity Frames in the desired orientation above the Leg Base. Install a #10 screw [SS268] and #10 washer [203-1390]
through each hole closest to the front and back edge of each side into a #10 Nut [203-1317]. Use a 5/16" wrench and #2 Phillips head
screwdriver to tighten the assembly until firmly secure.
2. Attach the Leg Base to the assembled vanity frame using four #10-24 x 1/2" screws [203-1530] and four #10 washers [203-1390]
included with Leg Base. Use a #2 Phillips head screwdriver to tighten until firmly secure.
1
2
© 2020 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
5
Part no. CB-209-1336 07/28/20
Freestanding Vanity Leg Base Accessory
