Robern VT-SPOMM Instrucciones De Instalación

INSTRUCTIONS
Note: Complete all required electrical work and cabinet assembly prior to installation of this mirror.
1. Loosen thumb screws on mounting plate, as shown in Figure 1. Do not separate the parts, the screws should remain partially threaded.
2. Align the mirror at an angle as shown in Figure 2, with the loosened mounting bar going into the track at the desired height. Rotate into position as shown
in Figure 2b. Note: Ensure the plastic bushing remains on the outside of the vertical track.
3. The mount should be centered with the channel as shown in Figure 3.
4. Tighten thumb screws securely while holding the mirror at desired height as shown in Figure 4. Once installed, the vertical position of mirror can be
adjusted by loosening the thumb screws slightly. If the mirror must be adjusted to a location above or below an installed shelf, repeat steps 1 through 4.
1
3
LIMITED WARRANTY ONE YEAR TERM
Robern warrants to the original purchaser that, it will, at its election repair, replace or make appropriate adjustment to products made by this company shown to have significant defects in material or
workmanship which are reported to Robern in writing within one (1) year from the date of delivery. Robern is not responsible for installation costs. The warranty is void in the event the product is damaged
in transit, or if damage or failure is caused by abuse, misuse, abnormal usage, faulty installation, damage in an accident, improper maintenance, or any repairs other than those authorized by Robern. At
the expiration of the one year warranty period, Robern shall be under no further obligation under any warranty, expressed or implied, including the implied warranty of merchantability. Robern shall not be
liable for any consequential damages arising out of or in connection with the use or performance of its products. Some states do not allow limitations on how long an implied warranty lasts or do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Any liability against Robern under any implied warranty, including the warranty
of merchantability, is expressly limited to the terms of this warranty. Permission to return any merchandise under this warranty must be authorized by Robern and returned prepaid by the purchaser. Claims
under this warranty should be sent directly to your dealer.
©2022 by Robern, Inc. All rights reserved.
© 2022 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376 www.robern.com
Installation instructions
VERTICAL TRACK SLIDING PULL-OUT
Installation Instructions - Save these instructions
2
4
1
MAG MIRROR VT-SPOMM
Ensure plastic
bushing stays
outside of
channel
Part no. 209-1442 6/21/22
Vertical Track Sliding Pull-out Mag Mirror