Power Supply; Unpacking Your Dryer - Haier GDE450AW Manual Para El Usuario E Instrucciones De Instalación

Power Supply Cord Kit
(Not supplied when sold in US. Must be purchased to meet local electrical codes.)
The dryer MUST employ a 3-conductor power supply cord NEMA 10-30 Type
SRDT rated at 240 Volt AC minimum, 30 Amp, with 3 open end spade lug
connectors with upturned ends or closed loop connectors and marked for use with
clothes dryers. (When sold in Canada - 4-wire power supply cord provided and
attached on dryer)
Dryers being installed in a manufactured (mobile) home MUST employ a 4-wire
power supply cord NEMA 14-30 type SRDT or ST (as required) rated to 240 Volt
AC minimum, 30 Amp, with 4 open-end spade lug connectors with upturned ends
or closed loop connectors and marked for use with clothes dryers. See Electrical
Connections for more information on a 4-wire system.
Outlet Receptacle
NEMA 10-30R receptacle should be located so the power supply cord is
accessible when the dryer is in the installed position. (Canada - NEMA 14-30R
receptacle)
ELECTRICAL REQUIREMENTS
Gas Dryer: (GDG450AW)
Circuit
Individual 15 Amp branch circuit fused with 15-Amp maximum time delay fuse or
circuit breakers.

Power Supply

3 wire, 120 Volt, 1 Phase, 60Hz, AC
Power Supply Cord
The dryer is equipped with a 120 Volt 3-wire power supply cord.
Note: This dryer is equipped with a three-prong grounding plug for your
protection against shock hazard and should be plugged into a properly
grounded three-prong receptacle. Do not under any circumstance cut or
remove grounding prong from plug.

UNPACKING YOUR DRYER

1. Remove all packaging material. This includes the foam base and all adhesive
tape holding the dryer accessories inside and outside.
2. Inspect and remove any remains of packaging, tape or printed materials
before using the dryer.
English
6